| Subject: |
|
oversized pistons |
| Name: |
|
Florian |
| Date Posted: |
|
May 8, 08 - 4:48 PM |
| Email: |
|
florian.pastoors@eu.takata.com |
| Message: |
|
Maybe anybody can help me with my doubts:
I let an 1050 block to bore it for oversized pistons (62.6) The responsible told me that this size, which is stamped on the piston is NOT the piston diameter but the cylinder size to be bored. I have serious doubts about that, because I think it is the piston diameter and some other values stamped on the piston ( i do not remeber exactly what it was, because I let him the pistons too) indicate the cylinder size for this pistons.
I would appreciate any comment, because he is doing that job for many years now and hadn´t any complaint regarding too small cylinder sizes( that´s what he says...and this block is the only one I have...
Regards,
Florian |
|
Replies:
|
|
|
|
|
Hey Webmasters! New Photo Album Service Launched - Check it out!
Reply
Forum
bravenet.com